Filler information Organization: (NECESSARILY) contact number: (NECESSARILY) Fax: E-mail: (NECESSARILY)
Basic data of the electric motor Place of installation (where is operated): Motor designation Rated power: kw Rated speed: rpm Rated voltage: V +/-%
Connection diagram: star triangle star / triangle the other
Degree of protection: standard (IP54) another IP additional shaft seal (magnetofluid dock)
Required insulation class: standard (F) another
Working hours: standard (S1) , PV % another
Direction of rotation right left reversible
Mounting type IM
Environmental conditions
Climatic modification according to GOST 15150: Installation: internal outdoor
Ambient temperature: standard (from - 20° C to + 40 ° C) another from -° C to +° C
Average value of relative humidity %at ° C
Installation altitude above sea level: standard (to 1000 m) the other m
presence of an aggressive environment (corrosive atmosphere, acid solutions, alkalis, dust), % content
the presence of an explosive atmosphere explosion protection marking
Zone type: Explosive atmosphere category: Ignition temperature:
idle start load start start Y / Δ soft starter
Soft starter type Starting current limit: Number of starts: cold; in hot
speed control required
Frequency converter type Speed regulation range:from rpm, to rpm, power frequency:from Hz, to Hz
Thermal motor protection (in the stator winding): RTS thermistors bimetallic sensors thermocouple TH(TO) other
Bearings: standard system bearings for increased loads SKF bearings insulating bearing (for PSP) Nipple for grease change and replenishment
Bearing fixation: drive side from the field side
Bearing temperature sensors: drive side from the field side
Characteristic of bearing temperature sensors: Pt100 50M TH(TO) other
Auxiliary terminal box on the motor housing for connecting temperature sensors Space for a sensor for measuring vibration in a bearing Install vibration sensor
Required type of vibration sensor Anti-condensation heater:W ° V
Condensate drain plug
Outer surface coating color:Outer surface coating color: Other RAL
Drive machine type (fan, pump, conveyor, compressor, etc.): Moment of inertia on the drive shaft of the mechanism: kg / m2
Axial load on the shaft end, N Radial load on the shaft end, reduced to the middle of the working end of the shaft, N Load characteristic: quadratic (М~n2) linear (М ~ n) constant (M = const)
Specify additional requirements in free writing:
Analog engine (type of, manufacturer)
I accept site agreement on the processing of personal data.
